Mityvac 07201 FLUID EVACUATOR PLUS User Manual download pdf (Page 4)

Page Number - 4

Form 822823

Extracting From and Dispensing Fluid into Transmission Cases and Differentials

1. Follow Steps 1 & 2 above. (See Extracting and Dispensing Motor Oil into a Crankcase)

2. Remove the transmission ﬂuid dipstick or ﬁll plug.

In some applications this may require jacking or lifting the vehicle. Use appropriate safety stands

to avoid serious or fatal injury.

3. Select and insert the appropriate diameter dipstick tube into the dipstick ﬁll hole until it reaches the

bottom of the transmission pan or gear case. Connect the main suction tube to the dipstick tube.

4. Insert the opposite end of the main suction tube into the 10mm x 90° tube connector on the top of the

reservoir tank. Take care that tube is in the connector all the way to prevent leakage.

5. Place the selector valve mounted on the side of the pump assembly to “EVACUATE”.

6. Raise the pump handle on the reservoir tank until it reaches its highest limit. Pump the handle approxi-

mately ten times. The unit will begin to extract the transmission ﬂuid from the transmission.

7. Once the transmission ﬂuid has been extracted, remove the expandable rubber plug from the reservoir

tank; pour the transmission ﬂuid from the tank into a suitable container, and dispose of the transmis-

sion ﬂuid in an appropriate manner. Rinse out the reservoir tank with clean solvent or engine degreas

er. Allow it to dry thoroughly.

8. If you wish to use the Fluid Evacuator Plus to dispense transmission ﬂuid, ﬁll the cleaned reservoir

tank with new transmission ﬂuid and simply switch the selector valve that is mounted on the side of the

pump assembly to “DISPENSE”.

9. Pull up on pump handle and continue pumping until the transmission is ﬁlled to the desired level.

10. Follow the operating instructions for your vehicle to properly check the transmission ﬂuid level.

Extracting and Dispensing Coolant into a Cooling System

Never remove the cap from the radiator or expansion tank while the engine is at operating tem-

perature. Always allow the engine to cool before removing the radiator cap or expansion tank

cap. The cooling system is under pressure. Failure to allow the engine to cool before attempting

to remove the cap could result in serious injuries.

1. Allow the engine to cool.

2. Remove the radiator/expansion tank cap.

3. Select the largest diameter dipstick tube and insert the tube into the radiator neck or expansion tank.

4. Insert the opposite end of the main suction tube into the 10 mm x 90° tube connector on the top of

the reservoir tank. Take care that the tube is in the connector all the way to prevent leakage.

1 2 3 4 5 6 7 8 9 ... 23 24

No comments

Mityvac 07201 FLUID EVACUATOR PLUS User Manual Page 4